Six Inch Strawberry Cake
1.
A six-inch round cocoa cake embryo is planned to be cut into three layers. Due to accidents, only two layers of about 1.5 cm thick can be cut. Those with a heart-shaped mousse mold can be pressed and cut, and those without a knife must be carefully trimmed. Into a heart shape. If you are afraid of failure, you can cut a heart shape with paper, stick it on the cake slice and carve the heart shape with a knife.
2.
Two pieces of trimming are completed. Use a knife to lightly carve a heart shape on one of the pieces. The safest way is to use paper to cut a paper pattern and paste it, and then carefully engrave it along the outline.
3.
After determining the position of the pattern, overlap the two cake slices and take out the heart.
4.
The effect is shown in the figure.
5.
Effect picture.
6.
130 grams of whipped cream, add 13 grams of sugar to beat.
7.
The state is the appearance of fine lines.
8.
I don't like to eat whipped cream, so the coating is relatively thin, depending on your own situation.
9.
Wash blueberries and strawberries and absorb moisture with kitchen paper. The strawberries must be evenly sized and cut in half. Strawberries are better placed symmetrically.
10.
The whipped cream is put into the piping bag, and the flower mouth is used to squeeze out a simple flower decoration. I use Sanneng 7142 Flower Mouth.
11.
Fill the gaps with blueberries and try to pick fruits of the same size.
12.
The bottom layer of the second piece of cake base is also coated with some light cream and lightly covers the first layer.
13.
Repeat the first layer of action. The surface layer was a bit negligent, and half a strawberry was placed less ๐๐๐ which caused the blueberry to have an incomplete heart shape๐๐The key is that after looking at the picture, I found that there is no way to remedy it, and I have eaten it in my stomach๐๐๐
14.
side view
15.
Life is always full of imperfections. This is probably the word I want to tell the girl the most.
16.
The inner core is taken out on the left, and the leftover cut material is sliced on the right.