by Big N's Kitchen
Difficulty
Hard
Time
2h
Serving
2
1. Put the milk, cream cheese, and butter in a container and heat it over water. The water temperature does not need to be too high, stirring slowly until all is melted.
2. Then separate the egg white and egg yolk, add the egg yolk to the mixed solution of milk cheese and butter one by one, and use a whisk to quickly stir while adding to prevent the egg yolk from preheating and solidifying.
3. Then take out this container, sieve the weighed starch and flour, and sift into the solution of step 2
4. Stir the flour and the solution thoroughly and set aside for later use
5. Put the egg whites in a large clean container without water and oil. It is recommended to be metallic.
6. Use a whisk to beat until the egg whites are bubbling (the whole process of whisking the egg whites is like stirring the meat, all beating in the same direction)
7. Then add the sugar in 3-4 times, and keep beating the egg whites.
8. Until the egg white is beaten to such a droopy tip, we call it wet foaming. Then beat a few times to defoam at low speed. (Dry foaming is suitable for ordinary sponge cakes. Such egg whites should be sent to the triangular tip to stand upright.) Whistling the egg whites is one of the key steps for this cake. Don't over-whip it, otherwise the cake will easily crack during the baking process.
9. Take out one-third of the beaten egg white and put it into the batter. After mixing it evenly, take out the remaining half and mix it evenly. (The cutting and mixing method is one of the more basic baking methods, which can effectively prevent the batter from being bubbled during the mixing process. If you can’t, I suggest you go to Baidu to watch the video. The text Xushun may not be vivid enough)
10. (How much egg white to mix into the batter does not need to be strictly regulated. The key to this step is to make the two materials of different densities can be mixed sufficiently, so you can do it according to your own habits) Then pour the batter Add the remaining egg whites and continue to cut and mix to mix evenly.
11. Prepare a cake mold and line the bottom with parchment paper.
12. Use a grater to wipe an appropriate amount of lemon zest into the stirred batter. It is better to hold a whole lemon in your hand. It is recommended to put more, as the taste of fresh lemon zest is relatively weak compared to lemon flavor.
13. Preheat the oven at 160°C for 10 minutes to bake in a bath. Place the cake on the lower layer of the oven and bake at 160 degrees for ten minutes. (For coloring)
14. The cake is slightly puffed up when it has been baked for about ten minutes. Then turn the heat to 130 degrees and bake for 60 minutes.
15. The cake that is almost finished should look like this, the surface is not cracked, and it is not as high as other cakes.
16. After baking, open the oven door to a gap and insert it like a spatula. This way, in order to prevent retraction, it is the same as the undercut, but I have tried the undercut, because this cake is too tender and easy to break. So later did I switch to this method to prevent retraction.
17. After about 40-50 minutes, you can take out the oven. At this time, the sides of the cake are basically separated from the mold, just find the plate and buckle out.
18. Put it in the refrigerator and freeze for more than 5 hours before eating. I left it for about 16 hours and the cake will be denser.
Tips:1. The source of lemon flavor can be lemon peel or lemon flavor. If you don't have a masher, you can remove the white part after removing the lemon peel, and cut the remaining skin into short filaments.
2. It is recommended to use a fixed bottom for the cake mold. If it is a mold with a movable bottom, be sure to wrap the bottom with tin foil first, and the height of the tin foil should be higher than the horizontal surface in the water bath method.
3. The water bath method is to put the cake mold in a larger baking pan, and then pour water into the baking pan. The height of the water is about 2 cm.









