Garland Bread
1. Weigh the material
2. Add liquid ingredients and milk powder to the bottom of the bread bucket
3. Add high flour, low flour and yeast on the top, put it in the bread machine to start the kneading program (my bread machine is two for 20 minutes)
4. Whipped to fully expanded state, cover, put in a warm place to ferment to double size
5. Take out and knead well
6. Divide into 4 parts
7. Take a portion and roll it out into a rectangle
8. Fold up and compact at 1/3
9. Fold down the remaining 1/3 of the upper part, compact and round
10. Wake up for 5 minutes after all rubbing
11. Then roll into thin strips about 60cm
12. Put up the word don
13. Let’s start the braid below, as shown in the figure from left to right
14. For everyone to see clearly, throw 2 up
15. 4 press 3
16. 1 press 4
17. 3 press 1
18. 4 toss up, 2 to press 3, this program is over
19. In this order, complete
20. Turn around and finish editing the other side
21. Take any end and roll the dough about one finger wide with a rolling pin (as thin as possible)
22. Then cover the tail on the other end
23. Wrap the extra part at the bottom of the bread
24. Put it in a baking tray for shaping
25. Put in the oven, ferment function, 20 minutes (put a bowl of hot water at the bottom) to 1.5 times the size
26. Brush egg liquid on the surface, preheat the oven at 180 degrees
27. Put it in the oven, middle level, up and down, 20-22 minutes (if the surface color is fast, you need to cover with tin foil)
Tips: 1: The temperature of the oven is for reference only, please adjust it according to your own oven temperament.
2: If the surface color is fast during the baking process, it should be covered with tin foil to avoid over-baking.
3: As the water content of flour is different, the amount of water should be flexibly increased or decreased, or it can be replaced with the same amount of milk