Leopard Banana Cake
1. First, let's make the banana filling. Peel and dic the bananas, put them in a container, and mash them with a fork
2. Then add 1 egg, 1 teaspoon cornstarch, 3 teaspoons fine sugar, 150ml milk, 2 drops of vanilla extract to the mashed banana. Stir everything well and put it in a small pot. Heat on low heat and use while heating. Continue stirring with the whisk, and finally add 1 teaspoon of cocoa powder, stir until it becomes a thick paste, then remove from the heat, and let it cool for later use. (Because there are too many steps, this step of cocoa powder forgot to take pictures)
3. Start preparing to draw the leopard print, first print out the leopard print pattern with the computer, place it on the baking tray, and then spread the baking paper. Take a deep basin, add 1 egg, 20 grams of fine sugar, stir evenly with a whisk, and heat it with warm water until the sugar is completely melted. The water should not be too hot, about 40 degrees.
4. Use an electric whisk to beat the egg liquid at high speed for 5 minutes, then switch to low speed and continue to beat for 2 minutes until the egg liquid swells finely. Sift in 17 grams of low-gluten flour, stir with a rubber spatula for 10 times, then add 10 grams of milk, and continue to stir for about 50 times
5. Add 1 teaspoon of cocoa powder to the mixed egg mixture, continue to mix evenly, put it into the decorator, and draw the light-colored part of the leopard pattern on the baking tray according to the pattern. Then add 1 teaspoon of cocoa powder to the cocoa egg mixture. After mixing evenly, the color of the egg mixture is darker than before. Then put it into the flower decorator and start painting the dark part of the leopard pattern.
6. Preheat the oven to 180 degrees, put the leopard flower in the oven and bake for 2 minutes, and then take it out after a little setting
7. Then start to make the main sponge cake, also take a deep basin, put 3 eggs, 60 grams of fine sugar, stir in warm water until the sugar melts
8. Use an electric whisk to beat at high speed for 5 minutes, then turn to low speed and beat for 2 minutes until the egg liquid swells finely (this step is the same as making leopard print)
9. Sift in 50 grams of low-gluten flour, stir with a rubber spatula for 10 times, then add 30 grams of milk, and continue to stir for about 50 times
10. Pour the egg mixture into a baking tray with a leopard pattern, shake it a few times to eliminate bubbles, put it in the oven at 180 degrees, and bake for 10-12 minutes
11. Take out the baked cake and let it cool. When it is completely cold, turn the leopard print side of the cake up and slowly tear off the baking paper
12. Cut the cake into 12-15 cm long squares, put it on a plastic wrap or a plastic bag, put the banana filling in the middle, slowly roll it up with the plastic bag from the bottom up, then tighten the left and right sides to form a candy-like shape, and put it in Refrigerate in the refrigerator for 2 hours, ready to eat after setting
Tips: When mixing low-gluten flour and milk, the egg mixture must be mixed and not stirred in circular motions. Be sure to wait for the cake to cool before tearing the baking paper, and tear it slowly to prevent the pattern from being torn.