Zebra Pattern Steamed Cake
1. Add cocoa powder to hot water and stir evenly to form cocoa paste (the cocoa paste mixed with hot water is very thick and not easy to defoam), set aside
2. Separate egg whites and egg yolks, sieve flour
3. Whisk the egg yolk, milk and corn oil evenly, add flour, mix into egg yolk paste, set aside
4. Add salt and vinegar to the egg whites, add sugar in three times, and beat until hard foaming (the small upright corners can be pulled out)
5. Take 1/3 of the egg white paste into the egg yolk paste, stir evenly with a rubber spatula, then pour the egg yolk paste into the remaining egg yolk paste, and mix until the egg yolk paste is completely fused with the egg yolk paste.
6. Take 1/3 of the egg batter and put it in the cocoa butter, stir evenly
7. Take 2 tablespoons and separate the original color paste and cocoa paste to avoid color mixing. Pour 2 tablespoons of the original color batter into the middle of the mold, and then pour 1 tablespoon of cocoa batter in the middle of the original color batter. Until the pouring is finished, move faster to prevent defoaming
8. In order not to affect the texture of the two colors of custard, I did not shake the mold, and only used fine chopsticks to slightly tidy the surface of the batter to eliminate large bubbles.
9. Seal the cake mold with plastic wrap or tin foil, or cover the mold with a dish to prevent water vapor from dripping on the surface of the cake
10. After the steamer is boiled, put it in a mold and keep it on a small and medium fire for 70 minutes. Small fire and large amount require a longer steaming time. Keep the fire on a medium and small fire. Do not open the lid for inspection or add water in the middle. This recipe has a large amount. If the steamer is not high enough, the lid will lift up when the cake expands. Therefore, I spread a cloth on the inside of the lid in advance to prevent water vapor from leaking out when the lid is lifted.
11. Turn off the heat, simmer for 3 minutes, take out the mold, quickly remove the plastic wrap (or tin foil), shake off the mold, remove the heat, and buckle
12. Demoulding, front. Full mold, no sunken, no waist collapse
13. Demoulding, the reverse side. Smooth and complete
14. Cut into pieces. Clear lines, fine organization
Tips: 1. The egg whites must be beaten to the hard foaming state, otherwise it will affect the fluffy of the cake.
2. The amount of water for steaming the cake must be enough at one time, and the lid of the pot must not be opened midway.
3. After the cake is out of the pan, quickly remove the plastic wrap, shake the mold to remove the heat, otherwise the cake will shrink.