Flower Bread
1. Put all the ingredients (except butter) into the bread bucket in the order of liquid first and flour
2. Finally, dig a hole in the flour to add yeast.
3. The bread machine chooses the kneading program, my bread machine is T06, and the kneading program is 30 minutes
4. After kneading the dough for 20 minutes, add butter
5. After the kneading program is over, the film condition is detected. If it is not ideal, you can run half of the kneading program, or take it out and beat it a few times. My bread machine generally produces a good film in one program.
6. After the kneading process is over, put the dough in a warm place for a shot, or directly in the bread machine.
7. When the dough grows to 2.5 times its size, dip your fingers in the flour and poke a hole in the middle of the dough. If the dough does not shrink, it proves that the dough has been finished.
8. Take out the dough and press it with the palm of your hand to exhaust.
9. After venting, the dough is shaped. The dough is divided into 8 equal parts, rounded, and placed in the mold. I used an 8-inch anode mold here, so it is filled with greased paper.
10. Put it in the oven, put a bowl of hot water underneath, turn on the fermentation gear and start the second round, until it doubles the size, take it out.
11. Preheat the oven at 170 degrees and brush with egg wash.
12. Oven 170 degrees, lower and middle level, 20 minutes. Pay attention to the coloring. The tin foil is colored and stamped. I went to see the baby at that time, and when I came back to cover the tin foil, the color was already dark.
13. The beautiful flower bread is out, although the color is a bit darker, but the taste is still great
Tips: Because the water absorption of flour is different, reserve 5% of the water when kneading the dough, and increase or decrease the water appropriately depending on the condition of the dough.
After the bread comes out of the oven, let it dry until warm and put it in a fresh-keeping bag for storage.